Premier Mounts PDS-002 Installation Instructions

PDS-002 Projector Bracket Installation Instructions
PDS-002 Bracket
(Qty 1)
6mm Quick Release
Button (Qty 1)
1. Invert the projector and place it on a soft and flat surface. Remove any foot
levelers that might possibly prevent the correct installation of the bracket.
2. Locate the two mounting points (quick release button mounting point and
knurl knob mounting point) located on the bottom of the projector .
3. Place the 6mm quick release button over the quick release mounting point
and secure it using the 1/4-20 Phillips Panhead screw .
4. Place the PDS-002 bracket keyhole slot over the quick release button and
slide the PDS-002 bracket forward.
5. Line up the knurl knob mounting point with the remaining mounting hole
and insert the M3 x 8mm knurl knob.
Installation Instructions
IN-PDS002.R0
1/4-20 Phillips Head
Screws
(Qty 1)
M3 x 8mm Security
Head Screws
(Qty 1)
M3 x 8mm Knurl
Knob (Qty 1)
1. Make all final placement adjustments at this time.
NOTE:
NOTE:
screwdriver to tighten 1/4-20 screw and fingertighten the M3 x 8mm knurl
knob.
Please refer to the PDS Base Box installation Instructions to attach
the PDS Base Box to the PDS-002 mounting bracket.
The projector (shown above) is for illustration purposes only .
PDS-002 Projector Bracket
When complete, use a
Page 1