Related Manuals for Premier Mounts PWM-503
Summary of Contents for Premier Mounts PWM-503
- Page 1 INSTALLATION MANUAL PLASMA DISPLAY MOUNT MODEL For service and parts contact: Premier Mounts 3130 E. Miraloma Ave Anaheim, CA USA 92806 Phone: (800) 368-9700 Fax: (800) 832-4888 www.mounts.com Visit us at:...
-
Page 2: Table Of Contents
Contents Safety & precautions Mount diagrams Parts List Optional Adapters Installing the mounting bracket Installing the mount Electrical Securing the mount Additional security - 2 -... -
Page 3: Safety And Precautions
Failure to properly install the PSM-V501F plasma panel could result in serious personal injury. Proper ventilation is required for the PDP-501MX plasma panel. Only Pioneer approved wall brackets should be used to mount the panel to ensure proper ventilation Contact Premier Mounts for any questions - 3 -... -
Page 4: Mount Diagrams
Mount Diagrams TILT BACK PLATE PART#: PSB-TBP MATERIAL: 12 (GA) CRS COLOR: Black powder coat Lag bolt access slot. Mounting points (4.5") used on installations other than wall mounting. Access hole for power or cables. Mounting points for additional security screws. -
Page 5: Parts List
Parts List HARDWARE LIST TOOLS NEEDED Phillips screwdriver Drill gun Soft material or a blanket Pencil ¼" drill bit Level Measuring tape Wrench with a 1/2" socket Stud finder CEILING ADAPTERS (OPTIONAL) PCA-1 – 4.5" Ceiling adapter mates directly to the PSB-TBP tilt back plate PSA-1 –... -
Page 6: Installing The Mounting Bracket
Installing the mounting bracket WARNING Proper installation procedure by qualified personnel as outlined in the installation instructions must be adhered to. Failure to do so could result in serious personal injury and possible damage to the plasma display. Step 1 CAUTION : The plasma displays are fragile and heavy. -
Page 7: Installing The Mount
Installing the mounts Step 3 Select the area where the plasma will be installed and make sure it can support the weight standards (see warning on page 3). Locate the 16" wood stud centers behind the wall using a (commercially available) stud finder and mark the center of the studs when found. Set the mounting bracket to the wall and mark the desired height by marking the center of the See fig 3 tilt back plate. -
Page 8: Electrical
To determine the desired viewing height, use the center slot opening in the wall mount as a center reference for the plasma television when mounted. Once the height is determined, use the bubble level to insure that the bracket is level. Next, using a pencil, mark the six (6) lag bolt slot openings on the mounting bracket. Before continuing, confirm the marks are located on the center of the studs. -
Page 9: Securing The Mount
Securing the mount Step 5 Warning: The plasma display is heavy and 2 people are needed to lift and install it. Failure to do so could result in serious personal injury. Before placing the plasma on the wall recheck all hardware for proper tightness and security. Before installing, become familiar with the way the plasma mount attaches to the wall mount.
Need help?
Do you have a question about the PWM-503 and is the answer not in the manual?
Questions and answers