Rules
After creating filters, click the Add button to set the rules on how to implement the
filters.
Filter Key — Select the filter to assign the rule.
Enable — Check this box to enable this rule.
Protocol — Select a protocol from the drop-down list. Options are TCP, UDP, or
ICMP.
Action — Select the action to execute when the rule requirement is met. Options
are:
Drop: Select to drop the packets if the rule requirement is met.
•
Permit: Select to allow packets to pass through if the rule requirement is
•
met.
Reject: Select to reject the packets if the rule requirement is met. Select
•
the Reject Type from the drop-down list.
Depending on the selected protocol and the selected action, the fields below may or
may not be displayed on the screen.
Origin IP Address — Enter the IP address of the origin of the packets.
Origin Mask — Enter the subnet mask of the origin of the packets.
Destination IP Address — Enter the IP address of the destination of the packets.
Destination Mask — Enter the subnet mask of the destination of the packets.
Origin Start Port and Origin End Port — Enter the starting and ending port range of
the origin of the packets.