Packet Filter; Filters & Rules; Filters - TRENDnet TEW-658BRM User Manual

Packet Filter

Filters & Rules
This page allows you to create packet filters and rules. These filters are used to
check each data that passes within your network. If the packet data does not meet
the requirements, the packet is either dropped or rejected.
To access the Filters & Rules page, click ADVANCED > Packet Filter > Filters & Rules
or click the Filters & Rules button.

Filters

Click the Add button to create a new filter.
Name — Enter desired filter name.
NOTE: The filter name cannot contain spaces.

Interface — Select the interface to implement the filter.
Type — Select In to filter incoming packets or select Out to filter outgoing packets.
Default Action — Select Drop to drop the packets or select Permit to allow packets
to pass through if the rule requirement is met.
Click the Apply button to save the filter or click the Cancel button to discard your
changes.
The new entry is listed on the FILTERS table. An Index and Key are automatically
assigned to each filter that you create. The Key is used to identify the filter when
assigning rules.
To edit a filter, click the corresponding icon. To delete a filter, click the
corresponding icon.