Dakota Digital LED Tail Lights for 1957 Chevy Car LAT-NR210 Installation Instructions
  1. Manuals
  2. Brands
  3. Dakota Digital Manuals
  4. Automobile Accessories
  5. LED Tail Lights for 1957 Chevy Car LAT-NR210
  6. Installation instructions

Dakota Digital LED Tail Lights for 1957 Chevy Car LAT-NR210 Installation Instructions

Led tail lights for 1957 chevy car
Hide thumbs
1
2

Advertisement

Table of Contents

MAN#650185

Kit Includes:

Installation:

1. Remove the three screws that secure the tail light lens and remove the lens.
2. Remove the light bulb
3. Push and twist to remove the plastic wire socket from the back side of the housing.
4. Now is a good time to clean the lens and housing. If lenses are in bad shape a new set is
recommended.
5. Remove the lock nut and flat plastic back plate from the back of the new LED assembly.
6. Make sure that one wire is still going through each hole in the
aluminum spacer. Insert the new LED assembly through the hole
where the original bulb and connector were located. Use caution
when feeding the wires through to avoid damaging the wire
insulation.
7. Guide the wires through the larger hole in the plastic back plate and slide
the back plate onto the stud sticking out the back side of the housing.
Ensure wires are not pinched to avoid shorting!
8. Secure the plastic back plate from the back side of the tail light housing
with the supplied #6 lock nut.
9. Make sure the original lens gasket is in place and replace the tail light
lens. Tighten the screws down carefully.
INSTALLATION INSTRUCTIONS
LAT-NR210
LED Tail Lights for 1957 Chevy Car
MAN#650185

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the LED Tail Lights for 1957 Chevy Car LAT-NR210 and is the answer not in the manual?

Questions and answers

Related Manuals for Dakota Digital LED Tail Lights for 1957 Chevy Car LAT-NR210

Summary of Contents for Dakota Digital LED Tail Lights for 1957 Chevy Car LAT-NR210

  • Page 1 MAN#650185 Kit Includes: Installation: 1. Remove the three screws that secure the tail light lens and remove the lens. 2. Remove the light bulb 3. Push and twist to remove the plastic wire socket from the back side of the housing. 4.
  • Page 2 This Warranty is in lieu of all other expressed warranties or liabilities. Any implied warranties, including any implied warranty of merchantability, shall be limited to the duration of this written warranty. No person or representative is authorized to assume, for Dakota Digital, any liability other than expressed herein in connection with the sale of this product.

Table of Contents