Dakota Digital LED Tail Lights for 1968 Impala LAT-NR251 Installation Instructions

Led tail lights for 1968 impala

MAN#650211

Kit Includes:

1. Remove all tail light lenses as described below while taking care to keep

the lenses with their housings.

2. Remove the three screws that hold the lens in and remove the lens from

the housing.

3. Remove the light bulb from socket.

4. Now is a good time to clean the lenses and the tail light housings. If the

lenses are in poor condition a replacement set is recommended.

5. Make sure the housings and lenses are clean and dry. Test fit the LED

assemblies by placing the LED assemblies in housings to check for a good fit. DO NOT

remove the backing from the tape yet! Note the places where the tape touches the housing.

6. Squeeze the primer tube to break the glass bulb and wet the brush end with primer. Rub the

primer on the housings at the places where the tape will touch. Treat all tail light housings at

the same time before the primer tube dries out.

7. Wait for a minimum of 5 minutes for the primer to dry and cure.

INSTALLATION INSTRUCTIONS

LAT-NR251

LED Tail Lights for 1968 Impala

Table of Contents

Do you have a question about the LED Tail Lights for 1968 Impala LAT-NR251 and is the answer not in the manual?

Page 1 MAN#650211 Kit Includes: Installation: 1. Remove all tail light lenses as described below while taking care to keep the lenses with their housings. 2. Remove the three screws that hold the lens in and remove the lens from the housing. 3.
Page 2: Service And Repair
This Warranty is in lieu of all other expressed warranties or liabilities. Any implied warranties, including any implied warranty of merchantability, shall be limited to the duration of this written warranty. No person or representative is authorized to assume, for Dakota Digital, any liability other than expressed herein in connection with the sale of this product.