Test And Verify; Compare - Disc Makers ReflexMax1 User Manual

load the recorder drives with high quality blank CD-R media. Press the ENT
button to start the process. The unit will analyze the master on the Src drive,
and then any disc in the recorder drives.The LCD will display the number of
discs that passed the test and then proceed directly to the copy process.
Upon doing a successful Test and Copy the following will display on the LCD.
3. Test and Copy
OK: 02
In this example, two discs were successfully tested and copied.
If the target blank CD-R has already been written to, or is damaged and can-
not be written to, the drive for this disc will not open. Likewise, if the data on
the master CD will not fit on the blank target CD, the drive will remain closed.
4. V
ERIFY
The Verify function is used to confirm that the master and the copy read the
same. Again this function operates similarly in both the Hard-Drive-to-Disc
and the Disc-to-Disc mode
1. Select the Verify function using the Up and Down arrows.
2. In the Hard-Drive-to-Disc mode: load the drives with the copied discs. The
unit will analyze the master on the hard drive, and then compare that to any
disc loaded in the recorder drives. The LCD will display the number of discs
that verified correctly and the number that failed the verification. Those that
verified correctly will be ejected from the recorders. All failures will remain in
the drives.
3. In the Disc-to-Disc mode: Load the top drive Src with the master disc and
load the recorder drives with the previously written media. Press the ENT
button to start the process. The unit will analyze the master in the Src drive,
and then any disc in the recorder drives.The LCD will display the number of
discs that verified and the number that failed. Those that verified correctly
will be ejected from the recorders. All failures will remain in the drives.
1-800-237-6666
In the example above, three discs verified correctly and one disc failed the
verification.
The F-> indicates that by pressing the ENT button the failed disc(s) will be
ejected from the recorders. Please be careful to remove the correctly verified
disc(s) before pressing ENT again.
To verify more duplicated discs, simply fill the recorders and press ENT,
again.
5. C
OMPARE
The Compare function takes the Verify function one step farther, it gives
details about the master and copied disc. It also ejects the disc upon a suc-
cessful comparison.
1. Select the Compare function using the Up and Down arrows.
2. In the Hard-Drive-to-Disc mode: load the drives with the copied discs. The
unit will analyze the master on the hard drive, and then compare that to any
disc loaded in the recorder drives. The LCD will display the number of discs
that compared correctly and the number that failed. Those that passed the
comparison will be ejected from the recorders. All failures will remain in the
drives.
3. In the Disc-to-Disc mode: Load the top drive Src with the master disc and
load the recorder drives with the previously written media. Press the ENT
button to start the process. The unit will analyze the master on the Src drive,
and then any disc in the recorder drives. The LCD will display the number of
discs that compared correctly and the number that failed. Those that passed
the comparison will be ejected from the recorders. All failures will remain in
the drives.
www.discmakers.com
4. Verify F->
OK: 03 Fail: 01
T
08