Functions; Copy And Test - Disc Makers ReflexMax1 User Manual

and pressing ENT button.
To start a new job, place a new master disc in the top drive, the SRC drive.
Then load as many recorders with high-quality blank media as needed.
F
UNCTIONS
1. C
OPY
The Copy function is the primary place to duplicate optical media.
In the Hard-Drive-to-Disc mode (the default setting), the LCD will display:
1. Copy
The copy is being made from the hard drive and specifically from Partition A.
In the Disc-to-Disc mode the LCD will display:
1. Copy
Notice there will be nothing to the right of 1. Copy.
Pressing the ENT button will initiate a copy operation.
2. T
EST
The Test function is used to check whether a disc will successfully copy. It sim-
ulates the copying process. When concluded no data will be written to the
writer drives. This function operates in both Hard-Drive-to-Disc and Disc-to-
Disc mode.
1. Select the Test function using the Up and Down arrows.
2. In the Hard-Drive-to-Disc mode: load the drives with high quality blank CD-R
1-888-800-4041
P:A
www.discmakers.com
media and press the ENT button to start the process. The unit will ana-
lyze the master on the hard drive, and then any disc in the recorder
drives. A message will be displayed regarding the results.
3. In the Disc-to-Disc mode: Load the top drive Src with the master disc and
load the recorder drives with high quality blank CD-R media. Press the ENT
button to start the process. The unit will analyze the master on the Src drive,
and then any disc in the recorder drives. A message will be displayed regard-
ing the results.
Upon successful testing, the following will display on the LCD. In this exam-
ple three discs were successfully tested. Any disc that passed the test will
automatically be ejected from the drives.
2. Test
OK: 03
If the target blank disc has already been written to, or is damaged and can-
not be written to, the disc will not be ejected. If the data on the master CD will
not fit on the target blank disc then the disc will not be ejected.
3. T C
EST AND OPY
The Test and Copy function incorporates the first two functions into one opera-
tion. It is used to check whether a disc will successfully copy and then goes on
to do the copy. First, the copy process is simulated and then the data is actual-
ly copied to the blank media.
1. Select the Test and Copy function using the Up and Down arrows.
2. In the Hard-Drive-to-Disc mode: load the drives with high quality blank CD-R
media and press the ENT button to start the process. The unit will analyze
the master on the hard drive, and then any disc in the recorder drives. The
LCD will display the process number of discs that passed the test and then
proceed directly to the copy.
3. In the Disc-to-Disc mode: Load the top drive Src with the master disc and
T
07