Disc Makers ReflexMax1 User Manual page 12

3. Press the Up or Down arrow to change the track in view. To select a track to
copy to the blank disc press the ENT key, a + will appear next to the track in
view. In the following example track 3 is in view and is selected for copying.
Select Track:
+3/31
TRACK IN VIEW
TOTAL TRACKS ON DISC
More than one track can be chosen from a CD but they will be recorded to
the destination in the order in which they are on the original CD. To change
the order of play, copy each track individually.
4. After selecting a track (or tracks) to copy press the Up arrow until End
appears. In this example one track is selected and the time for this track is
2:41.
Select Track:
End
If four tracks were selected the screen would show 4 Trk and give the total
time for all four tracks.
5. Load the other recorders—one or as many as needed—with Disc Makers
Ultra CD-Rs.
6. Press the ENT button and the ReflexMax will ask if all the selections are
made for this CD. Use the Up or Down arrow to change between Yes and No.
Pressing ENT with No on the LCD will take the user back to Select Track.
Pressing ENT with Yes on the screen will start the copying of the track (or
tracks) to the target blank CD.
End edit disc
and burn?
1-888-800-4041
3:18 1
TIME OF TRACK
1 Trk 2:41
YES
www.discmakers.com
7. When the copying ends the unit will display Burn Complete! OK: 01.
Press the ENT button. The LCD will display Continue edit next Disc? NO.
To change to another CD, Load the top recorder drive Src with another mas-
ter disc, press the up arrow to change the No to Yes and press ENT. This will
take you to the screen from Step 3. Repeat steps 3 through 6 to add more
tracks on the compilation.
8. When there are no more tracks to write to the compilation leave the Continue
edit next Disc? NO set to No and press the ENT key again. The following
screen will appear:
Close all discs
session?
Press ENT and the ReflexMax will close the CD. Once the CD is closed, no
additional tracks can be copied to the CD.
The LCD will display Close Complete OK: ... Fail: ... the number of discs
closed successfully will be next to OK and they will be ejected, any failures
will remain in the recorder drives.
The ReflexMax can compile to the hard drive as well, in Step 2 use the Down
arrow to to select 10-02. Edit Track CD to hard drive Edit and press ENT.
Steps 3 and 4 will be the same to select the tracks to copy. It is not neces-
sary to load any media. Step 6 will load the selected track(s) to the hard
drive. The last few steps will proceed as follows:
7. When the copying ends the unit will display Image load OK, pressing ENT will
display Continue edit next Disc? NO Leaving this set to No and pressing ENT
the screen will display Burn or Move to partition? Burn. Use the down arrow
to change the Burn to Move then press ENT. Select Partition A will be dis-
played. Use the down arrow to select a partition to copy to and press ENT.
You will see Moving to P: ... and then OK! to confirm the writing to the hard
YES
T
11