Prescan, Disc Info, And Select Source; Images And Handling Images - Disc Makers ReflexMax1 User Manual

Upon completion of this test the following will display on the LCD.
Compare
Fail:1
In this example, three discs compared successfully and one was different.
The successful disc will be ejected.
Pressing the ENT button will identify the source for the comparison and the
size of the source in MB. Pressing ENT again will display the first (topmost
recorder) drive and the condition of the comparison, Identical is any passed
disc. Pressing the ENT button will cycle through all the recorder drives and
report the condition.
Press the ESC key to return to the main menu.
The failed conditions are: TOC not match, Cannot read TOC, or Read disc
error.
6. P
RESCAN
The Prescan function only looks at the master CD. If the ReflexMax is in Hard-
Drive-to-Disc mode, the data in the partition is examined. If the Disc-to-Disc
mode is current, any disc in the source Src drive will be examined. This is used
to verify that the master can be read correctly without errors
In the Hard-Drive-to-Disc mode: Select the loaded master to analyze and press
the ENT button. The unit will analyze the master on the hard drive and a mes-
sage will be displayed Prescan OK!
In the Disc-to-Disc mode: Load the top drive Src with the master disc. Press
the ENT button to start the process. The unit will analyze the master on the Src
drive, and then a message will be displayed regarding the results.
7. D I
ISC NFO
The Disc Info function only looks at the master CD. To use this function, it is
necessary to change to the Disc-to-Disc mode. See Step 8 Select Source. It will
1-888-800-4041
OK:3
Diff:1
www.discmakers.com
display the session and tracks on the CD, total time of the CD, and size of
the CD.
1. Select the Disc Info function using the Up and Down arrows.
2. Load the Src drive with the master disc.
3. Press the ENT button to start the process. Pressing the Up and Down arrow
will scan through the information.
8. S S
ELECT OURCE
The Select Source function is used to select the mode the ReflexMax will oper-
ate under. When the Hard Drive is chosen as the source Src the unit will be in
Hard-Drive-to-Disc mode. Choosing any recorder drive as the source Src will
cause the unit to copy in Disc-to-Disc mode.
1. Select the function using the Up and Down arrows.
2. Press the Up and Down arrow to cycle through the available sources.
Typically the sources are Src: hard drive ØØ IDEØ Master and Src: CD-RW
Ø1 IDE1 Slave. The CD-RW drives are numbered from Ø1 to Ø7 with the top
drive being Ø1 and the bottom drive being Ø7.
3. Press the ENT button to select the source in view on the LCD. The display will
say the source and ... selected!
4. Press the arrow keys to move to another function.
9. I
MAGE
The Image function is used to manipulate images on the hard drive. There are
six sub functions that can be utilized.
9.01 Load: use this sub-function to load an image of the CD master onto the
hard drive
1. Press the Down arrow until you see 9. Image then press the ENT button, you
should see 9-01. Image P: A Load.
2. Load the top drive with the master disc and press the ENT button. The mas-
ter disc will copy to the hard drive and the display will read Image Load OK.
9.02 Delete Image: use this sub-function to delete an image from the hard
drive
T
09