Dakota Digital LED Tail Lights for 1971 Bel Air LAT-NR390 Installation Instructions

Led tail lights for 1971 bel air

Download this manual

MAN#650239

Kit Includes:

Installation:

1. Remove the original bulb connectors from the bottom side of the housing.

2. Remove the plastic housing from the vehicle.

3. Remove the tail light lens by gently prying the housing away from the lens tabs.

4. Now is a good time to clean the lens and housing. If lenses are in bad shape a new set is

recommended.

5. Remove the round mounting plate from the bottom of the LED assembly. It is attached with

two lock nuts.

INSTALLATION INSTRUCTIONS

LAT-NR390

LED Tail Lights for 1971 Bel Air

MAN#650239

Page 1 MAN#650239 Kit Includes: Installation: 1. Remove the original bulb connectors from the bottom side of the housing. 2. Remove the plastic housing from the vehicle. 3. Remove the tail light lens by gently prying the housing away from the lens tabs. 4.
Page 2 6. Insert each new LED assembly through the hole where the original bulb and connector were located. Use caution when feeding the wires through the socket opening to avoid damaging the wire insulation. 7. Feed the wires through the large hole in the back plate and attach the back plate onto the back side of the housing.
Page 3: Service And Repair
This Warranty is in lieu of all other expressed warranties or liabilities. Any implied warranties, including any implied warranty of merchantability, shall be limited to the duration of this written warranty. No person or representative is authorized to assume, for Dakota Digital, any liability other than expressed herein in connection with the sale of this product.