D-Link xStack DGS-3200-10 User Manual page 95

xStack
The user-changeable parameters are as follows:
Parameter
Algorithm
Group ID
Type
Master Port
State
Member Ports
Active Ports
After setting the previous parameters, click Apply to allow your changes to be implemented.
®
DGS-3200 Series Layer 2 Gigabit Ethernet Managed Switch
Description
Toggle between MAC Source Dest and IP Source Dest.
Select an ID number for the group, between 1 and 5 for the DGS-3200-10, between 1 and 8
for the DGS-3200-16, and between 1 and 12 for the DGS-3200-24.
This drop-down menu allows users to select between Static and LACP (Link Aggregation
Control Protocol). LACP allows for the automatic detection of links in a Port Trunking Group.
Choose the Master Port for the trunk group using the drop-down menu.
Use the drop-down menu to toggle between Enabled and Disabled. This is used to turn a
port trunking group on or off. This is useful for diagnostics, to quickly isolate a bandwidth
intensive network device or to have an absolute backup aggregation group that is not under
automatic control.
Choose the members ports for the trunked group. Up to eight ports per group can be
assigned to a group.
Shows the ports that are currently forwarding packets.
82