D-Link xStack DGS-3200-10 User Manual page 205

xStack
To set the Access Rule for IP, adjust the following parameters and click Apply.
Parameter Description
Access ID (1-200)
Type in a unique identifier number for this access. This value can be set from 1 to 200.
Auto Assign – Ticking this check box will instruct the Switch to automatically assign an Access ID
for the rule being created.
Action Select Permit to specify that the packets that match the access rule are forwarded by the Switch,
according to any additional rule added (see below).
Select Deny to specify that packets that match the access rule are not forwarded by the Switch
and will be filtered.
Select Mirror to specify that packets that match the access rule are mirrored to a port defined in
the config mirror port command. Port Mirroring must be enabled and a target port must be set.
Priority (0-7) Tick the corresponding check box if you want to re-write the 802.1p default priority of a packet to
the value entered in the Priority field, which meets the criteria specified previously in this
command, before forwarding it on to the specified CoS queue. Otherwise, a packet will have its
incoming 802.1p user priority re-written to its original value before being forwarded by the Switch.
For more information on priority queues, CoS queues and mapping for 802.1p, see the QoS
section of this manual.
Replace Priority Tick this check box to replace the Priority value in the adjacent field.
Replace DSCP (0- Select this option to instruct the Switch to replace the DSCP value (in a packet that meets the
63) selected criteria) with the value entered in the adjacent field.
Note: When an ACL rule is added to change both the priority and DSCP of an IPv4 packet,
only one of them can be modified due to a chip limitation. Currently the priority is
changed when both the priority and DSCP are set to be modified.
This field allows the user to enter a VLAN Name in the space provided, which will instruct the
VLAN Name
Switch to examine the VLAN identifier of each packet header.
®
DGS-3200 Series Layer 2 Gigabit Ethernet Managed Switch
Figure 6 - 15. Add Access Rule window for IPv4
192