D-Link xStack DGS-3200-10 User Manual page 220

xStack
To set the Access Rule for IP, adjust the following parameters and click Apply
Parameter Description
Access ID (1-100) Type in a unique identifier number for this access. This value can be set from 1 to 100.
Action Select Permit to specify that the packets that match the access rule are forwarded by the Switch,
according to any additional rule added (see below).
Select Deny to specify that packets that match the access rule are not forwarded by the Switch
and will be filtered.
VLAN Name Allows the entry of a name for a previously configured VLAN.
Tick the check box and enter the name of the Time Range settings that has been previously
Time Range
configured in the Time Range Settings window. This will set specific times when this access rule
Name
will be implemented on the Switch.
Ports Ticking the All Ports check box will denote all ports on the Switch.
To view the settings of a previously correctly configured rule, click the co rresponding Show Details button on th e CPU Access
Rule List window to view the following window:
®
DGS-3200 Series Layer 2 Gigabit Ethernet Managed Switch
Figure 6 - 36. Add Access Rule window for IPv4
Figure 6 - 37. CPU Access Rule Detail Information window for IPv4
207