D-Link xStack DGS-3200-10 User Manual page 208

xStack
Use this to limit RX bandwidth for the profile being configured. This rate is implemented using the
RX Rate (1-15625)
following equation: 1 value = 64kbit/sec. (ex. If the user selects an RX rate of 10 then the ingress
rate is 640kbit/sec.) The user many select a value between 1 and 15625 or tick the No Limit
check box. The default setting is No Limit.
Time Range Tick the check box and enter the name of the Time Range settings that has been previously
Name configured in the Time Range Settings window. This will set specific times when this access rule
will be implemented on the Switch.
Counter Use the drop-down menu to specify if the Counter feature should be Enabled or Disabled.
Ports When a range of ports is to be configured, the Auto Assign check box MUST be ticked in the
Access ID field of this window. If not, the user will be presented with an error message and the
access rule will not be configured. Ticking the All Ports check box will denote all ports on the
Switch.
To view the settings of a p reviously correctly configured rule, click the corresponding Show Details button on the Access Rule
List window to view the following window:
To establish the rule for a previously created Access Profile:
To configure the Access Rules for IPv4, open the Access Profile List window and click Add/View Rules for an IPv4 entry. This
will open the following window:
To remove a previously created rule, click the corresponding Delete Rules button. To add a new Access Rule, click the Add Rule
button:
®
DGS-3200 Series Layer 2 Gigabit Ethernet Managed Switch
Figure 6 - 19. Access Rule Detail Information window for IPv6
Figure 6 - 20. Access Rule List window for IPv4
195