D-Link DGS-3212SR User Manual page 102

The following parameters are displayed:
Parameter
User Name
Group Name
SNMP Version
Auth-Protocol
Priv-Protocol
To add a new entry to the SNMP User Table Configuration, click on the Add button on the SNMP User Table
page. This will open the SNMP User Table Configuration page, as shown below.
The following parameters can be set:
Parameter
User Name
Group Name
D-Link DGS-3212SR Layer 2 Gigabit Ethernet Switch
Description
An alphanumeric string of up to 32 characters. This is used to identify the
SNMP users.
This name is used to specify the SNMP group created that can request
SNMP messages.
V1 – Indicates that SNMP version 1 will be used.
V2 – Indicates that SNMP version 2 will be used.
V3 – Indicates that SNMP version 3 will be used.
None − Indicates that no authorization protocol is in use.
MD5 − Indicates that the HMAC-MD5-96 authentication level will be used.
SHA − Indicates that the HMAC-SHA authentication protocol will be used
None − Indicates that no authorization protocol is in use.
DES − Indicates that DES 56-bit encryption is in use based on the CBC-
DES (DES-56) standard.
Figure 18-3. SNMP User Table Configuration
Description
An alphanumeric string of up to 32 characters. This is used to identify the
SNMP users.
This name is used to specify the SNMP group created that can request
SNMP messages.
92
.