Introduction To Switch Management - D-Link DGS-3212SR User Manual

Introduction to Switch Management

Login to Web Manager
Web-based User Interface
Basic Setup
Switch Information
IP Address
User Accounts
Saving Changes
Factory Reset
Restart System
Introduction
All software functions of the DGS-3212SR can be managed, configured, and monitored via the embedded web-
based (HTML) interface. The switch can be managed from remote stations anywhere on the network through a
standard browser such as Netscape Navigator/Communicator or Microsoft Internet Explorer. The browser acts as
a universal access tool and can communicate directly with the Switch using the HTTP protocol.
The Web-based management module and the Console program (and Telnet) are different ways to access the same
internal switching software and configure it. Thus, all settings encountered in web-based management are the
same as those found in the console program.
Login to Web Manager
To begin managing your Switch simply run the browser you have installed on your computer and point it to the
IP address you have defined for the device. The URL in the address bar should read something like:
http://123.123.123.123, where the numbers 123 represent the IP address of the switch.
In the page that opens, click on the Login to make a setup button:
This opens the management module's main page.
The switch management features available in the web-based manager are explained below.
D-Link DGS-3212SR Layer 2 Gigabit Ethernet Switch
NOTE: The Factory default IP address for the switch is 10.90.90.90.
Figure 3-1. Login Button
Section 3
22