Download Settings From Tftp Server; Upload Settings To Tftp Server - D-Link DES-3550 User Manual

DES-3550 Layer 2
Type
Information about firmware on the Switch can be viewed in the Firmware Management
table in the same screen. It holds the following information:
Parameter
ID
Boot Status
Version
Size
Date
From
User
Set Boot
Delete

Download Settings from TFTP Server

To download a settings file from a TFTP server, click on the TFTP Service folder in the
Maintenance folder and then click the Download Settings from TFTP Server link:
Enter the IP address of the TFTP server and specify the location of the switch settings file on
the TFTP server.
Click Start to record the IP address of the TFTP server and to initiate the file transfer.

Upload Settings to TFTP Server

To upload the switch settings to a TFTP server, click on the TFTP Service folder in the
Maintenance folder and then click the Upload Settings to TFTP Server link:
Fast Ethernet Switch User's Guide
Specify the purpose of the firmware:
Download: Clicking this radio button will specify a download to the Switch.
This will be the firmware that the Switch will immediately use.
Update: Clicking this radio button will save the firmware to the Switch's
memory but not configure the Switch for this firmware. The Switch may hold
two firmware versions specified as Section 1 and Section 2.
Description
The user defined Section ID of the firmware on the Switch.
The firmware that is currently being run on the Switch will be identified in this
field with the term "Boot."
The runtime version of the firmware.
The size, in bytes, of the firmware.
The date that the firmware was added to the Switch.
The IP address of the Server from which the firmware came.
The name of the user who downloaded the firmware.
Click the Apply button in this field to set the firmware version to be used
upon the next boot up of the Switch.
Click the in this column to permanently delete the corresponding
firmware from the Switch
Figure 9- 2. Download Configuration
157