D-Link DES-3550 User Manual page 92

DES-3550 Layer 2
The following parameters can be set for Ethernet:
Parameter
Profile ID (1-255)
Type
Vlan
Source Mac
Destination Mac
802.1p
Ethernet type
Port
The page shown below is the IP Access Profile Configuration page.
Fast Ethernet Switch User's Guide
Figure 6- 41. Access Profile Table (Ethernet)
Description
Type in a unique identifier number for this profile set. This value can be set
from 1 – 255.
Select profile based on Ethernet (MAC Address), IP address, or packet
content mask. This will change the menu according to the requirements for
the type of profile. Select Ethernet to instruct the Switch to examine the
layer 2 part of each packet header. Select IP to instruct the Switch to
examine the IP address in each frame's header. Select Packet Content
Mask to specify a mask to hide the content of the packet header.
Selecting this option instructs the Switch to examine the VLAN part of each
packet header and use this as the full or partial criterion for forwarding.
Source MAC Mask - Enter a MAC address mask for the source MAC
address.
Destination MAC Mask - Enter a MAC address mask for the destination MAC
address.
Selecting this option instructs the Switch to examine the 802.1p priority value
of each packet header and use this as the, or part of the criterion for
forwarding.
Selecting this option instructs the Switch to examine the Ethernet type value
in each frame's header.
The user may set the Access Profile Table on a per-port basis by entering
a port number in this field.
92