Application's Authentication Settings; Authentication Server Group Settings - D-Link DES-3550 User Manual

DES-3550 Layer 2
Click Apply to implement changes made.

Application's Authentication Settings

This window is used to configure switch configuration applications (console, telnet, web) for
login at the user level and at the administration level (Enable Admin) utilizing a previously
configured method list.
The following parameters can be set:
Parameter
Application
Login Method List
Enable Method List
Click Apply to implement changes made.

Authentication Server Group Settings

This window will allow users to set up Authentication Server Groups on the Switch. A server
group is a technique used to group TACACS/XTACACS/TACACS+ server hosts into user-
defined categories for authentication using method lists. The user may define the type of
server group by protocol or by previously defined server group. The Switch has three built-in
Authentication Server Groups that cannot be removed but can be modified. Up to eight (8)
authentication server hosts may be added to any particular group.
Fast Ethernet Switch User's Guide
Switch will accept authentication attempts. Users failing to be
authenticated after the set amount of attempts will be denied access
to the Switch and will be locked out of further authentication
attempts. Command line interface users will have to wait 60 seconds
before another authentication attempt. Telnet and web users will be
disconnected from the Switch. The user may set the number of
attempts from 1 to 255. The default setting is 3.
Figure 7- 6. Application's Authentication Settings
Description
Lists the configuration applications on the Switch. The user may configure
the Login Method List and Enable Method List for authentication for users
utilizing the Console (Command Line Interface) application, the Telnet
application, and the WEB (HTTP) application.
Using the pull down menu, configure an application for normal login on the
user level, utilizing a previously configured method list. The user may use the
default Method List or other Method List configured by the user. See the
Login Method Lists window, in this section, for more information
Using the pull down menu, configure an application for normal login on the
user level, utilizing a previously configured method list. The user may use the
default Method List or other Method List configured by the user. See the
Enable Method Lists window, in this section, for more information
119