Download Configuration File; Upload Configuration - D-Link DES-3526 User Manual

xStack DES-3526 / DES-3526DC Layer 2 Stackable Fast Ethernet Managed Switch User Manual
Information about firmware on the Switch can be viewed in the Firmware Management table in the same window. It holds the
following information:
Parameter Description
ID The user-defined Section ID of the firmware on the Switch.
Boot Status The firmware that is currently being run on the Switch will be identified in this field with the term
"Boot".
Version The runtime version of the firmware.
Size The size of the firmware, in bytes.
Date The date that the firmware was added to the Switch.
From The IP address of the Server from which the firmware came.
User The name of the user who downloaded the firmware.
Set Boot Click the Apply button in this field to set the firmware version to be used upon the next boot up of
the Switch.
Click the X in this column to permanently delete the corresponding firmware from the Switch.
Delete

Download Configuration File

To download a settings file from a TFTP server, click on the TFTP Service folder in the Maintenance folder and then the
Download Configuration File link:
Enter the IP address of the TFTP server and specify the location of the switch settings file on the TFTP server.
Click Start to record the IP address of the TFTP server and to initiate the file transfer.

Upload Configuration

To upload the switch settings to a TFTP server, click on the TFTP Services folder, located in the Maintenance folder, and then
click the Upload Configuration link:
Enter the IP address of the TFTP server and the path and filename for the switch settings on the TFTP server.
Click Start to record the IP address of the TFTP server and to initiate the file transfer.
Figure 9- 2. Download Settings from TFTP Server window
Figure 9- 3. Upload Settings to TFTP Server window
155