Transmitted (Tx) - D-Link DES-3526 User Manual

xStack DES-3526 / DES-3526DC Layer 2 Stackable Fast Ethernet Managed Switch User Manual
Parameter
Time Interval
Record Number
Crc Error
Under Size
Over Size
Fragment
Jabber
Drop
Show/Hide
Clear
View Table
View Line Chart

Transmitted (TX)

Click the Transmitted (TX) link in the Error folder of the Monitoring menu to view the following graph of error packets
received on the Switch.
To view the Transmitted Error Packets Table, click the link
Description
Select the desired setting between 1s and 60s, where "s" stands for seconds. The default
value is one second.
Select number of times the Switch will be polled between 20 and 200. The default value is
20.
Counts otherwise valid packets that did not end on a byte (octet) boundary.
The number of packets detected that are less than the minimum permitted packets size of 64
bytes and have a good CRC. Undersize packets usually indicate collision fragments, a nor-
mal network occurrence.
Counts packets received that were longer than 1518 octets, or if a VLAN frame is 1522
octets, and less than the MAX_PKT_LEN. Internally, MAX_PKT_LEN is equal to 1522.
The number of packets less than 64 bytes with either bad framing or an invalid CRC. These
are normally the result of collisions.
The number of packets with lengths more than the MAX_PKT_LEN bytes. Internally,
MAX_PKT_LEN is equal to 1522.
The number of packets that are dropped by this port since the last Switch reboot.
Check whether or not to display Crc Error, Under Size, Over Size, Fragment, Jabber, and
Drop errors.
Clicking this button clears all statistics counters on this window.
Clicking this button instructs the Switch to display a table rather than a line graph.
Clicking this button instructs the Switch to display a line graph rather than a table.
Figure 8- 11. Tx Error Analysis window (line graph)
View Table, which will show the following table:
142