Config Firmware Image; Ping Test - D-Link DES-3526 User Manual

xStack DES-3526 / DES-3526DC Layer 2 Stackable Fast Ethernet Managed Switch User Manual

Config Firmware Image

The Config Firmware Image window allows users to configure firmware images saved in the memory of the Switch. To access
the following window, click Maintenance > MULTIPLE IMAGE Services > Config Firmware Image.
This window offers the following information:
Parameter
Image
Action
Click Apply to implement changes made.

Ping Test

Ping is a small program that sends ICMP Echo packets to the IP address you specify. The destination node then responds to or
"echoes" the packets sent from the Switch. This is very useful to verify connectivity between the Switch and other nodes on the
network.
The user may use Infinite times radio button, in the Repeat Pinging for field, which will tell the ping program to keep sending
ICMP Echo packets to the specified IP address until the program is stopped. The user may opt to choose a specific number of
times to ping the Target IP Address by clicking its radio button and entering a number between 1 and 255. Click Start to initiate
the Ping program.
Figure 9- 6. Config Firmware Image window
Description
Select the firmware image to be configured using the pull-down menu. The Switch allows two
firmware images to be stored in the Switch's memory.
This field has two options for configuration.
Delete – Select this option to delete the firmware image specified in the Image field
•
above.
Boot – Select this option to set the firmware image specified above as the boot up
•
firmware for the Switch. This firmware will be set as the boot up firmware after a
switch reboot has been performed. The default setting has firmware image ID 1 as
the boot up firmware image for the Switch unless specified here.
Figure 9- 7. Ping Test window
158