TRENDnet TDM-C504 User Manual page 32

Default Route: Click the radio button to "Enable" or "Disable" the default Route
functionality.
Configuration Procedure:
1. From the WAN – Channel Config page, click and select PPPoA connection mode from the
Channel Mode drop down manual. The default PPPoA connection setup is displayed.
2. Select the Channel Mode to "PPPoA". Set the parameters VPI/VCI and Encapsulation mode
according to the ISP setting.
3. Click the radio button and select the Encapsulation type ( LLC or VC-Mux).
Note: Your ADSL service provider or your ISP will supply these. In this case the ADSL service
provider is using LLC.
4. Check the radio button to "Enable" or "Disable" the NAPT setting. Leave as it's default setting if
your ADSL provider or ISP didn't provide any setting information.
Note: NAPT: Network Address and Port Translation: An extension of NAT, NAPT maps many
private internal addresses into one IP address. The outside network (WAN) can see this one
IP address but it cannot see the individual device IP addresses translated by the NAPT.
5. Enter your Username and Password which will be provided by your ADSL provider or ISP.
6. Select the Connection Type form the drop down manual or leave as it's default setting (Continuous).
7. Click the radio button to "Enable" or "Disable" the Default Route functionality or leave as its
default (Enable).
8. Click "Add" button after setup.
9. You can "Edit" (
10. Click "Admin/ Commit/Reboot". Press "Commit" to save the settings into flash memory.
11. The new settings will take effect after reboot the system.
12. The following window display indicates the system restarting process.
13. The following screen display after the system rebooting process. The System Home page will
shows all the connection status and system information.
1483 Routed Mode
1483 Routed: When 1483 Routed mode is selected, the following screen will pop-up. Fixed (Or Static) is
used whenever a known Fixed (Or Static) IP is assigned. The accompanying information such as the Subnet
mask, Local IP Address and the Remote IP Address should also be specified. Up to three Domain Name
Server (DNS) addresses can also be specified (Click Services – DNS – DNS Server configuration page and
fill in the DNS server IP address provided by your ISP). These servers would enable you to have access to
other web servers. Valid IP addresses range is from 0.0.0.0 to 255.255.255.255.
) or "Delete" ( ) the existing connection profile under the Actions column.
16