TRENDnet TDM-C504 User Manual page 28

Configuration Procedure:
1. From the WAN – Channel Config page, click and select 1483 MER connection mode from the Channel
Mode drop down manual. The default 1483 MER connection setup is displayed.
2. Under the Channel mode, enter the values of VPI and VCI settings.
3. Click the radio button and elect the Encapsulation type ( LLC or VC-Mux).
Your ADSL service provider or your ISP will supply these. In this case the ADSL service
Note:
provider is using LLC.
4. Check the radio button to "Enable" or "Disable" the NAPT setting. Leave as its default setting if your
ADSL provider or ISP didn't provide any setting information.
NAPT: Network Address and Port Translation: An extension of NAT, NAPT maps many
Note:
private internal addresses into one IP address. The outside network (WAN) can see this one
IP address but it cannot see the individual device IP addresses translated by the NAPT.
5. Under the WAN IP mode, enter the "Local IP Address", "Subnet Mask" and "Remote IP Address" if
you are using the Fixed IP (Or Static IP) mode. These information/data will be provided by your ADSL
Service provider or ISP.
6. Under the WAN IP mode, if you select DHCP as your connection type, nothing needed to fill. In this
case the ADSL service provider is using Dynamic IP (Or DHCP) mode.
7. Check the radio button to "Enable" or "Disable" the Default Route setting. Leave as its default setting
if your ADSL provider or ISP didn't provide any setting information.
8. Click "Add" button after setup.
9. You can "Edit" ( ) or "Delete" ( ) the existing connection profile under the Actions column.
10. Click "Admin/ Commit/Reboot". Press "Commit" to save the settings into flash memory.
11. The new settings will take effect after reboot the system.
12. The following window display indicates the system restarting process.
13. The following screen display after the system rebooting process. The System Home page will shows all
the connection status and system information.
PPPoE Mode
PPPoE: When PPPoE Mode is selected from the Channel Mode drop down manual, the following
screen display. Point-to-Point Protocol (PPP) is a method of establishing a network connection between
network hosts. PPPoE, also known as RFC 2516, adapts PPP to work over Ethernet for ADSL connections.
PPPoE provides a mechanism for authenticating users by providing User Name and Password fields and it is
a connection type provided by many ISP or Telecom.
LLC and VC-Mux are two different methods of encapsulating the PPP packet. Contact your ISP to make
sure which encapsulation is being supported.
12