TRENDnet TDM-C504 User Manual page 11

Following are the steps to properly connect your TDM-C504 4-PORT ADSL 2/2+ Modem Router by
Ethernet Cable (RJ-45):
1. Turn off your computer/notebook.
2. Connect the ADSL port of your TDM-C504 4-Port ADSL2/2+ Modem Router to the wall jack of the
ADSL/ADSL2/ADSL2+ Line with a RJ-11 cable.
3. Connect the Ethernet cable (RJ-45) from your TDM-C504 ADSL2/2+ Modem Router to the
Ethernet Adaptor on your computer.
4. Connect the Power adaptor to the TDM-C504 ADSL2/2+ Modem Router and plug it into a Power
outlet.
The Power light will be on after turning on the TDM-C504.
!
Use the Power Adaptor exclusively in combination with the equipment
supplied and do not use any other kind of power adaptor for the
!
equipment.
5. Turn on your computer.
6. Refer to the next section to setup or configure your system's Network Adaptor.
11