Configuring The Communication Mode Manually - Canon imagePROGRAF iPF655 User Manual

Network Setting
Item
Location
Administrator
Phone
Comments(E-mail)
Security Settings
Item
New Password
Confirm
On the Security settings screen, besides entering a password, you can specify other security-related information,
such as IP address-based SNMP or TCP usage restrictions, MAC address-based access restrictions, or IPP and
FTP authentication settings.
7.
Click OK to activate the settings.

Configuring the Communication Mode Manually

This topic gives instructions for configuring the communication mode manually.
10
1.
On the Tab Selection screen of the Control Panel, press ◀ or ▶ to select the Settings/Adj. tab (
2.
Press the OK button.
764
The Set./Adj. Menu is displayed.
3.
Press ▲ or ▼ to select Interface Setup, and then press the OK button.
4.
Press ▲ or ▼ to select Ethernet Driver, and then press the OK button.
5.
Press ▲ or ▼ to select Auto Detect, and then press the OK button.
Configuring the Communication Mode Manually
> Network Setting >
Enter the location where the device is installed.
(0–32 characters)
Enter the administrator's name.
(0–32 characters)
Enter the administrator's contact information.
(0–32 characters)
Enter any comments regarding the administrator.
(0–32 characters)
Details
Enter the new password.
(0-9999999)
Enter the new password again to confirm it.
(0-9999999)
Note
• If the Tab Selection screen is not displayed, press the Menu button.
Details
Default Setting
blank
blank
Default Setting
blank
blank
blank
blank
).
iPF655