Install the Ink Tanks
•
Handle the ink tanks carefully. Do not drop or
apply excessive pressure to them.
•
If the Scanning Unit (Cover) is left open for more
than 10 minutes, the Print Head Holder moves
to the right. In this case, close and reopen the
Scanning Unit (Cover).
•
Be sure to use the supplied ink tanks.
Hardware Setup
1
2
Pull the orange tape (1) in the direction of the
arrow to peel off the protective film and remove
the film (2) completely.
2
A
1
While pressing down with your left thumb, twist off
the orange protective cap (A) located on the bottom
of the ink tank.
•
Do not touch the electrical contacts (B) or open ink port (C)
on the ink tank. The machine may not print properly if you
touch them.
•
Do not push the sides of the ink tank; ink may splash.
C
B