Install The Ink Tanks; Align The Print Head - Canon PIXMA MX7600 Series Setup Instructions

3

Install the Ink Tanks

Note
For the ink tanks compatible with this machine, refer to the back cover of the Quick
Start Guide.
Remove and discard the orange protective cap located on the
a
bottom of the ink tank.
Protective Cap
Ink Port
Electrical Contacts
Do not press!
Important
• Do not touch the electrical contacts.
• Do not touch the ink port.
Insert the ink tank into the right-hand slot and press the
b
mark on the ink tank until it clicks into place.
Make sure the ink lamp lights red.
c
Refer to the color guide on
the Print Head Lock Lever.
Part no. QT5-0072-V02 © 2008 Canon Inc.
4
Install the Clear Ink Tank
Remove the orange tape in the direction of the arrow to peel
a
off the protective film from the clear ink tank.
Do not touch!
Push the tab and open the Clear Ink Tank Locking Cover.
b
c Be sure that the clear ink tank is properly aligned when
inserting.
d Close and press the round, indented portion on the Clear Ink
Tank Locking Cover until it snaps firmly into place, locking the
ink tank.
e Close the Scanning Unit (Printer Cover).
Caution
For your safety, always firmly grip the areas illustrated when closing the Scan-
ning Unit (Printer Cover).
Important
The machine starts the preparatory operation. It takes about 2 minutes. Do not
start another operation until the machine has stopped making operating noises.
Note
If the Alarm lamp lights and an error message is displayed on the LCD, refer to "An
Error Message Is Displayed on the LCD" in the Quick Start Guide.
5

Align the Print Head

Close the Paper Output Tray and pull out the Cassette from the
a
machine.
Load four sheets of plain paper in the Cassette with the
b
printing side facing DOWN and the leading edge to the
far side, align the paper stack against the right side of the
Cassette, then slide the Paper Guides to fit to the loaded paper
stack.
Paper Guide
Insert the Cassette into the machine.
c
Push the Cassette all the way into the machine.
Make sure that Yes is selected in the message requesting
d
head alignment, then press the OK button.
Note
Print Head alignment takes about 9 minutes to complete. Do not start another
operation until the machine has stopped making operating noises.
The pattern is printed. And Print Head is aligned automatically.
OK
Note
• The pattern is printed in black and blue.
• When Automatic Print Head Alignment cannot be executed correctly, the message
"Auto head align has failed." is displayed on the LCD. Refer to "An Error Message
Is Displayed on the LCD" in the Quick Start Guide.
Hardware setup and Print Head alignment are complete.
For fax users
To use a fax, you need to set the telephone line type setting properly
on the machine.
If you are unsure of your telephone line type, contact your telephone
company.
Select the receive mode according to your needs.
• When you receive mainly faxes and sometimes voice calls:
→ FAX priority mode
• When you have a dedicated telephone line for fax use only:
→ FAX only mode
• When you receive mainly voice calls and sometimes faxes:
→ TEL priority mode
• When you subscribe to a ring pattern detection service provided by
your telephone company, and you want to receive a fax only if the
machine detects the pattern for fax:
→ DRPD
For details on how to confirm and change the settings, refer to the
Quick Start Guide.
For USB connection and software installation, proceed to "2
Easy Setup Instructions for USB Connection and Software
Installation."
For wired LAN connection, refer to the Network Setup Guide.
XXXXXXXX PRINTED IN THAILAND