Scanning An Image Into Your Macintosh; Pre-Scanning An Image - Brother DCP-7030 Software User's Manual

Scanning an image into your Macintosh

You can scan a whole page, or scan a portion after pre-scanning the document.
Scanning a whole page
a
Put the document face up in the ADF, or face down on the scanner glass.
b
Adjust the following settings, if needed, in the Scanner Setup dialog box:
Resolution
Scan Type
Document Size
Brightness
Contrast
c
Click Start.
When scanning has finished, the image appears in your graphics application.

Pre-Scanning an image

The PreScan button is used to preview and also lets you crop any unwanted areas from the image. When
you are satisfied you are scanning the correct area, click the Start button in the Scanner Setup dialog box to
scan the image.
a
Load your document.
b
Click PreScan.
The whole image is scanned into your Macintosh
c
Drag the mouse pointer over the portion you want to scan.
d
Put the document in the ADF again.
Note
If you put the document on the scanner glass in a, skip this step.
®
®
and appears in the Scanning Area.
Scanning
9
9
9
9
150