Mortise lock
tcwi1 series;
tcip1 series
corbin russwin access 800 series mortise locks are available in wifi (wi1) and poe (ip1)
configurations (15 pages)
BHD Trim 8200 Mortise Lock Installation Instructions 1. Mortise Lock Handing Instructions NOTE: RED SURFACE OF LOCKING PIECE MUST FACE SECURE SIDE OF DOOR. To rotate locking piece: 1. Position lockbody with red surface of locking piece visible. 2. Insert blade type screwdriver into locking piece slot to rotate locking piece. 3.
BHD Trim 8200 Mortise Lock Installation Instructions 2. Mortise Lock Function Changing Instructions Green Catch Screw How to change function of lock: Green catch screw must be located in following three (3) locations as designated on lock case to create desired function: 1.
BHD Trim 8200 Mortise Lock Installation Instructions 3. Mortise Lock Door Preparation & Installation Important: Be sure to hand the lockbody before installing. See Section 1. 1. Insert mortise lock into door and fully tighten 1” lock mounting combination screws. (Figure 2) 2.
Page 6
BHD Trim 8200 Mortise Lock Installation Instructions 3. Mortise Lock Door Preparation & Installation 8. Remove lockbody from door. 9. TURN-PIECE FUNCTIONS ONLY: Drill one middle hole (.290”) and two outer holes (3/8”) halfway through door. (Figure 6) Ø3/8” 10. COIN-TURN FUNCTIONS ONLY: Drill two holes (1/8”) halfway through door. (Figure 7) Ø.290”...
BHD Trim 8200 Mortise Lock Installation Instructions 4. BHD Trim Installation Strike Lip 1. Install strike using 3/4” strike mounting screws. NOTE: STRIKE MUST BE ORIENTED WITH STRIKE LIP TOWARDS PULL SIDE OF DOOR. (FIGURE 10) Figure 10 2. CYLINDER FUNCTIONS ONLY: Slide cylinder(s) through spring, spacer and collar, threading into lockbody until cylinder face is flush with collar.
Page 8
BHD Trim 8200 Mortise Lock Installation Instructions 4. BHD Trim Installation 6. Align inside adapter plate assembly with outside assembly posts and secure with two (2) #8-32 screws. (Figure 15) 7. Tighten rose firmly onto adapter plate assembly by turning clockwise on plate threads. Align holes and install rose torx screw to plate assembly with security torx screwdriver.
BHD Trim 8200 Mortise Lock Installation Instructions 5. Turn-Piece Installation 1. Install turn-piece loosely using two (2) turnpiece mounting screws. (Figure 21) NOTE: MAKE SURE LOCK IS UNLOCKED AND TURN-PIECE IS ROTATED AWAY FROM LATCH. (FIGURE 22) 2. Adjust location of turn-piece on door until turn-piece rotates easily, then fully tighten mounting screws.
Page 11
WARNING This product can expose you to lead which is known to the state of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65warnings.ca.gov. WARNING Attention Installer: Improper installation may result in damage to the product and void the factory warranty.
Need help?
Do you have a question about the SARGENT BHD Trim 8200 and is the answer not in the manual?
Questions and answers