Install Door; Verify Hand And Bevel Of Door; Prep Door According To Supplied Door Markers; Install Door Position Switch (Dps). (Figure 16) - Assa Abloy Corbin Russwin ED5200SN Series Installation Instructions Manual

ED5200(S)N & ED5600N Series with Aperio™ Technology
Exit Devices - Includes Rim and Mortise
Installation Instructions
7
Mortise Exit Installation Instructions
a
Verify Hand and Bevel of Door (Figure 14)
1. Door should be fitted and hung.
2. Verify box label for size of exit device, function and hand.
b
V Prep Door According to Door Marker FM430 (Figure 15)
Note: For door manufacturer templates, visit
www.corbinrusswin.com and reference
template # T31237 (Wood).
c

Install Door Position Switch (DPS). (Figure 16)

1. Insert DPS into raceway on latch edge of door.
2. Push wires through raceway toward lock prep.
3. Push DPS firmly into place by hand.
Do not tap switch with any tool.
4. Install magnet into door frame. Push firmly into place by
hand. See instruction A7983.
Caution: If DPS is not installed or is installed improperly,
door status monitoring features will not function.
For installation assistance contact Corbin Russwin
1-800-543-3658 • techsupport.corbinrusswin@assaabloy.com
Copyright © 2022, ASSA ABLOY Access and Egress Hardware Group, Inc. All rights reserved.
Reproduction in whole or in part without the express written permission of ASSA ABLOY Access
and Egress Hardware Group, Inc. is prohibited.
Outside
of Door
Raceway for
Auxiliary Hard-
Power
Left Hand
Reverse
LHR
Figure 14
Wood Door
Preparation
Door
Position
Switch
Through-bolt
Holes
Figure 15
Figure 16
12
Inside
Right Hand
Reverse
RHR
Inside
of Door
Raceway for
Auxiliary Hard
Power
Trim
Tailpiece
Hole
FM431 12/22