Install Exit Device - Assa Abloy Corbin Russwin ED5200SN Series Installation Instructions Manual

ED5200(S)N & ED5600N Series with Aperio™ Technology
Exit Devices - Includes Rim and Mortise
Installation Instructions
6
Rim Exit Installation Instructions, continued
e

Install Exit Device

1. Feed trim harness and ground wire through upper hole in cutout. (Figure 7).
2. Seat device against door being careful to align vertical trim tailpiece to engage with
cross hole of device cam. (Figure 8).
3. Fasten device to trim assembly using two (2) 1/4-20 pan head screws. (Figure 9)
4. Follow instructions packed with device to secure device to door.
5. Tighten all four (4) screws. (Figure 10)
When installing trim, pull wires completelythrough door to avoid
contacting motor assembly, as this may cause loss of function.
Outside
of Door
Figure 7
Tailpiece
Figure 9
For installation assistance contact Corbin Russwin
1-800-543-3658 • techsupport.corbinrusswin@assaabloy.com
Copyright © 2022, ASSA ABLOY Access and Egress Hardware Group, Inc. All rights reserved.
Reproduction in whole or in part without the express written permission of ASSA ABLOY Access
and Egress Hardware Group, Inc. is prohibited.
Outside
of Door
Figure 8
Inside
of Door
Figure 10
Tailpiece
Inside
of Door
Tighten
securely
10
FM431 12/22