In100 Installation Instructions; Install Outside (Reader) Escutcheon And Inside Mounting Plate - Assa Abloy Corbin Russwin ED5200SN Series Installation Instructions Manual

ED5200(S)N & ED5600N Series with Aperio™ Technology
Exit Devices - Includes Rim and Mortise
Installation Instructions
8

IN100 Installation Instructions

a

Install Outside (Reader) Escutcheon and Inside Mounting Plate

1. Orient reader so LED lens is at top. (Figure 24)
2. Feed cable/connector through door from outside to
inside.
3. Install reader to outside of door by aligning
mounting posts with door preparation holes. Hold
reader flush against door while ensuring proper
alignment.
4. Feed reader harness and DPS connectors through
inside mounting assembly and gasket if required*.
(Figure 25)
Note:
• Do not run wires through bottom flange hole in
plate - it will damage wires and controller connector.
(Figure 25, Figure 26)
• Route wires around flange, do not route wires
through flange hole. (Figure 25)
5. Tuck excess cable into wire hole on inside of door.
6. Begin to secure mounting assembly by partially
tightening two (2) through-bolts on inside of
door while ensuring proper alignment as reader is
secured. (Figure 25)
7. Secure ground lug with #6-32 machine screw.
(Figure 26)
Notes:
• Gasket is required for outdoor installations
• Do not use gasket for fire-rated openings
• If installing with gasket, separate gasket from
mounting plate to feed cables/connectors through
holes as indicated (Figure 25)
• Once cables/connectors are fed
through, reattach gasket to
mounting plate
For installation assistance contact Corbin Russwin
1-800-543-3658 • techsupport.corbinrusswin@assaabloy.com
Copyright © 2022, ASSA ABLOY Access and Egress Hardware Group, Inc. All rights reserved.
Reproduction in whole or in part without the express written permission of ASSA ABLOY Access
and Egress Hardware Group, Inc. is prohibited.
Note: Cable lengths exaggerated for illustrative purposes.
Reader
Assembly
with Harness
Figure 25
Figure 26
LED
Figure 24
Inside
of Door
Gasket*
15
Mounting
Plate
Through-bolt
DPS
Reader Harness
Through-bolt
Lockbody
Harness
Ground Lug
FM431 12/22