Troubleshooting - Kenmore SPOTLITE GO KW1050 Use & Care Manual

Review this table to find do-it-yourself solutions for minor
performance problems. Any service needed, other than maintenance
described in this Use & Care Guide, should be performed by a qualified
service agent.
WARNING
Disconnect electrical supply before performing maintenance to
the spot cleaner. Failure to do so could result in electrical shock or
personal injury.
PROBLEM
The spot
cleaner will not
run.
Poor job of dirt
pick-up.

TROUBLESHOOTING

POSSIBLE CAUSE
Unplugged at wall outlet. Plug in firmly.
Defective wall outlet.
The motor is damaged.
Dirty water tank is not
installed correctly.
Dirty water tank is full.
The suction hose is
clogged.
Float valve is activated.
Check with a good appliance or
lamp. Be sure the power cord
plug is fully plugged into a good
wall outlet.
Call 1-877-531-7321 (US) / 1-844-
608-3081 (CA) for assistance.
Check the dirty water tank for
correct installation. Ensure it is
installed in place.
Empty the dirty water tank.
Clean the hose.
Empty the dirty water tank.
- 18 -
SOLUTION