Kenmore SPOTLITE GO KW1050 Use & Care Manual page 12

WARNING
Personal Injury and Product
Damage Hazard
· When any abnormality/failure
occurs, stop using the product
immediately and disconnect
the power plug.
· DO NOT use outlets above
counters. Damage from cord
to items in surrounding area
could occur.
WARNING
To reduce the risk of electric
shock, this appliance has a
polarized plug (one blade is
wider than the other). This plug
will fit in a polarized outlet only
one way. If the plug does not
fit fully in the outlet, reverse
the plug. If it still does not fit,
contact a qualified electrician
to install the proper outlet. Do
not change the plug in any
way.
5. Press the power button to turn
the spot cleaner on. The spot
cleaner starts in normal mode
by default.
USING THE SPOT CLEANER
6. Select the desired cleaning
mode by pressing the mode
button. Pressing the mode
button will switch the spot
cleaner into: Normal Mode
Heated Mode
For ordinary stains, select the
Normal Mode. The normal
mode indicator will glow a
steady green light to indicate
the status.
For stubborn stains, select the
Heated Mode. The heated mode
indicator will flash yellow while
the unit warms up. After about
15 seconds, the heated mode
indicator will stop flashing and
a steady green light will glow
to indicate the heated mode is
ready for use.
WARNING
Scalding Risk.
When in the Heated Mode,
do not touch the nozzle and
sprayed water with your hands.
NOTE:
Cool water may spray
out of the hose before the hot
water is sprayed.
7. Hold the tool about 1 inch
over the stain to be cleaned.
Squeeze the spray trigger to
spray a generous amount of
cleaning solution over the
soiled area. Use the brush on
the tool to agitate stains by
scrubbing in a back and forth
motion.
- 12 -
Normal Mode.