Installer Settings; Privacy Notice - Aiphone JVS-1V Installation Manual

Installer settings

ATTENTION
 Be sure to configure the settings according to the
connected devices. Otherwise, the station may not
operate properly.
NOTE
 While in the settings menu, no operations such as calls or
notifications can be performed.
 The station will enter standby mode (the display will turn
off) after about one minute of no operation. If this occurs,
any unfinished setting changes will be lost.
Installer setting items
No. Item
1 Contact output time (*)
Option output Sets the option
duration output duration time.
Door release Sets the unlocking
duration duration for the
electric door lock.
2 Initialize Resets all settings to
default. All images
saved in built-in
memory will also be
deleted.
(*): The setting values should be the same as those of other
monitor station.
Installer setup menu screen
Setting
Details value
([ ]: Default)
1/[5]/10/20/30
(sec)
1/[5]/10/20/30
(sec)
-
Setting procedure (e.g., setting the
door release duration)
1
Tap one of the function buttons in standby mode.
The menu screen will be shown.
2
Tap and hold
The installer setup menu screen will be shown.
3
Tap the function button ( ) or ( ) to select
then tap the function button (✔).
The contact output time screen will be shown.
4
Tap the function button (
5
Tap the function button ( ) to adjust the door
release duration.
6
Tap the function button (✔) to apply changes.
ATTENTION
 Be sure to tap the function button (✔) to apply changes.
 Changes will not be applied if

Privacy notice

https://www.aip-info.net/legal/privacy/
-12-
for 5 seconds or more.
) to select .
is pressed.
,