Signode BXT3-32 Operating Instructions Manual page 8

WARNING
Following hazards can result in injuries:
Loose and falling packaged goods in the case of faulty seal
Check the weld seal. Never transport packaged goods if loads looks unbalanced or
improper (Section 5.2). Multiple welds in the same place are not permitted because this
leads to faulty seals!
Never lift packaged goods on the strapping, risk of injury
The strapping is designed in such a way that it is only intended to secure the packaged
goods during transport, storage etc.
Risk of explosion in EX (Explosive) zones
The tool must not be used in areas where explosions can occur as a result ot the environ-
ment or products being used.
Moving parts of the tensioning device, risk of crushing
Do not grasp in the area of moving parts.
Breaking straps, risk of injury
When being tensioned the strap may break and whip out. Do not stand in line with the
strap while it is being tensioned. Wear eye protection.
Strap ends snapping back, risk of injury
When cutting the strap, hold the upper portion and stand safely away from the strap. Do
not stand in line with the strap while it is being tensioned. Wear eye protection.
Compressed air for cleaning work, risk of injury
When cleaning with compressed air, no air must penetrate the body via skin lesions. Use
a blow gun with a multi hole nozzle. Wear eye protection.
CAUTION
The following dangers can result in minor or moderate injury:
Vibration and noise exposure
When operating the tool, wear ear and hand protection (cut-proof gloves).
The vibration/noise level specified in these instructions has been measured according to
a measurement method standardised in EN 60745 and can be used for the comparison of
power tools with each other. It is also suitable for a preliminary estimation of the vibration/
noise load.
The vibration/noise emission value measured may deviate from the specified value
depending on the actual application, the strap used and the manner of operation. Under
certain circumstances, the vibration/noise load may be increased over the entire work
period. For a more accurate assessment of the vibration/noise load, the times should
also be considered when the device is switched off, or is running but not actually being
used. This could reduce the vibration/noise load significantly over the entire work period.
Define additional safety measures against the effect of vibrations for the protection of the
operator, such as, for example: maintenance of the power tool, keep hands warm and
organisation of work processes.
!
ATTENTION
Avoid damage to the tool:
Water damage
Do not clean the tool with water or steam. When using the tool outdoors, protect it from
rain.
Use only original spare parts
Using non-original spare parts will void the warranty and any liability.
8 of 26
V 04.21_EN
SIGNODE BXT3-32