General Instructions; Fitting The Feet; Electrical Connection - Fagor NC-2500 Instructions For Use Manual

impagi.qxd 8-09-2003

1. GENERAL INSTRUCTIONS

Take the radiator out of its packing box and
remove any polystyrene pieces or any other
packaging material that might be lodged
inside it.
Make sure that the radiator has not been
damaged during transit and that the mains
cable is in working order.

2. FITTING THE FEET

Serie NC (
See rating label)
Remove the feet and the castors from the
polystyrene packing.
Fit the castors to the spindles on the feet
and push firmly until they click into posi-
tion (fig. 1).
Pull each castor to check that it is fitted
correctly.
Fit the feet to the bottom of the radiator
using the threaded bar and wing nut
provided. Fit only between the external
elements as shown in figures 2, 3 and 4.
Model with foot without castor
Some models have one foot without
castors. To mount, proceed as follows:
Mount the foot with castors following the
above instructions, only between the
external elements on the side opposite
to the controls (see figure 5).
Mount the foot without castors by inser-
ting the two guides (A fig. 5) into the
holes on the bottom of the control box
(fig. 5).
Fit the tooth into the slot provided and
lock the foot with the eye screw (fig. 6).
After fitting, turn the radiator back into
the vertical operating position.
12:07 Pagina 9
GB
• Switching on
9 7
Serie RA (
See rating label)
Remove the feet and the wheels from the
polystyrene packing. Turn the radiator
upsidedown on a rug or a soft surface in
order to prevent damaging the paint finish.
Insert the anchor tabs on the feet into the
slots in the radiator (fig. 7).
Use the 2 screws supplied with the
appliance to fasten the feet in position (fig.
8). Fit the wheels to the spindles on the feet
and push firmly until they click into
position.
Pull each wheel to check that it is correctly
inserted.

3. ELECTRICAL CONNECTION

• Before using the appliance check that
your supply voltage is the same of that
shown on the rating label of the unit and
that the power socket and power supply
line correspond to the load specified.
• Check also that the current capacity of
your fuses. CONNECT YOUR HEATER TO
EARTH PROVIDED SOCKET ONLY.
• This appliance complies with EEC
Directive 89/336, relating to electro-
magnetic compatibility.
4. HOW TO USE IT
Plug it in; move thermostat to highest
setting and switch it on as follows:
a) on-off units with single heat
setting:
- key on "I" = ON
- key on "O" = OFF
b) units with three heat settings:
- only right key on "l" = low heat
- only left key on "ll" = medium heat
- both switches on "l" "ll" = high heat
To turn appliance off, switch off both
switches or remove plug from wall
socket.