Cleaning And Maintenance - Fagor FIC-381E Installation And User Manual

5. CLEANING AND MAINTENANCE

Before any cleaning or maintenance, disconnect the appliance either by unplugging it from the socket or by turn-
ing off the mains switch.
To disconnect the appliance from the mains, unplug it. When doing so, do not pull the appliance's mains cable.
DEFROSTING
- If your refrigerator does not have a low temperature compartment, defrosting will occur automatically. During
defrosting, drops of water run down the back wall. The water, which passes along a channel, flows into the tray
situated in the compressor where it evaporates.
- If the refrigerator has a low temperature compartment, to reduce electricity consumption it is recommended that
you remove the excess frost (3 or 4 mm) from the inside and/or cooling grilles. The thawing process must be car-
ried out as quickly as possible as if the temperature of the food rises, the preservation period will decrease.
- You can use a plastic spatula to speed up the process, but under no circumstances use metal, sharp or pointed
objects (knives, forks, metal spatulas, etc.), as they may damage the refrigerating circuit. Never use humidifiers,
braziers, hair dryers or de-icing sprays to speed up this process either. The refrigerating circuit may be damaged
irreparably and be a source of danger if the appliances operate with R-600 A.
- To defrost the freezer, follow the instructions below:
1. Unplug the appliance from the mains socket or disconnect the main switch.
2. Remove the food from the freezer and store it in cold insulation bags in a cool place.
3. Turn the thermostat to the position.
4. Let the discharge water flow into a container.
5. Collect the water which forms during defrosting with a sponge or cloth.
6. Also dry the walls and/or cooling grilles.
7. Plug into the mains.
8. Turn the thermostat to the desired position (Please refer to the "TEMPERATURE REGULATION" section).
MAINTENANCE
- Before starting any cleaning, disconnect the plug from the mains.
- To move or remove the drawers, pull them forwards until the front part stops, turn them upwards and remove
them completely; to position the shelf, follow the reverse procedure.
- Clean the inside when defrosting.
- To clean the inside and the accessories, we recommend that you use a water and bicarbonate of soda solution.
Avoid:
• Abrasive powders, detergents or soap.
• Scouring pads or plastic materials.
• Aggressive products (alcohol, thinners, etc.).
- Clean the outflow opening frequently, which is located on the rear wall, with either a brush or a blunt instrument
(e.g. a cotton bud).
- Rinse in clear water.
- Clean the seal of the door with water and dry it carefully.
- Carefully dry all the components and leave the door ajar for a few minutes.
- You can now place the food inside the appliance.
- Clean the outside with a soft, damp cloth.
- Clean the ventilation grille of the motor and condensor with a vacuum cleaner or soft brush, taking care not to
damage or separate the internal connections.
- For brief periods when you are away, we recommend that you leave the appliance plugged in.
50