Table of Contents
Advertisement
4.6
MODIFYING A PART-PROGRAM
To modify a part-program the following steps must be taken:
* Press
* Use the pointer to select from the left-hand column the part-program you wish to modify.
After selecting the program, the CNC lets you:
Erase an operation
Move an operation to another position
Add or insert a new operation
Modify an already existing operation.
4.6.1
ERASING AN OPERATION
To erase an operation follow these steps:
* Use the pointer to select the operation to be erased, in the right-hand column.
* Press
The CNC will display a message at the bottom, requesting the confirmation of the erasing
operation.
If you press
column.
If you press
4.6.2
MOVING AN OPERATION TO ANOTHER POSITION
To move an operation to another position take the following steps:
* Use the pointer to select the operation to be moved from the right-hand column.
* Press
The CNC will display this operation in highlighted text.
* Place the cursor after the operation which the operation is to be moved to and press
Example:
Select the "User cycle 5" and press
Move the cursor onto the "User cycle 8" and press
Chapter 4 - page 6
to access the list of part-programs stored.
the CNC will erase the operation selected and update the right-hand
the operation is not erased and the erasing operation is left.
You have
1.- User cycle 2
2.- User cycle 5
3.- User cycle 11
4.- User cycle 3
5.- User cycle 1
6.- User cycle 8
7.- User cycle 9
MCO-TCO work mode
You want
1.- User cycle 2
2.- User cycle 11
3.- User cycle 3
4.- User cycle 1
5.- User cycle 8
6.- User cycle 5
7.- User cycle 9
Advertisement
Table of Contents
