Autonomous SmartDesk One Assembly Instructions Manual page 8

Operation Guide
3) Remove the upper height limit
① Adjust the desk to the position where the upper height limit has been set.
② Press up and down buttons together for less than 3 seconds.
③ Keep pressing the up button while releasing the down button and clicking the down button 3 or more times in succession.
④ The keypad beeps once and the setting is completed.
4) Remove the lower height limit
① Adjust the desk to the position where the lower height limit has been set.
② Press up and down buttons together for less than 3 seconds.
③ Keep pressing the down button while releasing the up button and clicking the up button 3 or more times in succession.
④ The keypad beeps once and the setting is completed.
5) Within the adjustable up and down limit travel, the digital display will flash regardless of whether
the setting or cancellation of the limit is successful or not, which can be judged by actual operation.
6) When overriding the set upper limit or lower limit, in the metric system, the difference between the set
upper limit or lower limit position and the original upper limit or lower limit position is at least 1 cm; in the
imperial system, it is at least 0.1 inch.
5. Set up Child lock
1) When the screen shows numbers, press the "M" button for 8 seconds until the screen shows "LOC", then
switch to the locked status, other operations of the keypad will not take effect.
2) When the screen shows "LOC", press the "M" button for 8 seconds until the screen shows numbers, then
switch to the unlocked status and normal operation can be performed.
3) If users release the button before the display is switched, the system will exit the child lock setting
function.
6. Preset Starting Display Height
1) Press the down button until the desk reaches the lowest position, release the down button. Press and
hold the down button again for 5 seconds until the digital display on the screen flashes. The flashing lasts
for 10 seconds. The setting status will exit if there is no operation.
2) Preset the required starting display height value by using the up and down buttons.
3) After the preset, stop operating for 10 seconds, the digital display on the screen will stop flashing, and
the setting is completed.
7. Switch Metric and Imperial Display
1) Press the "1" and "2" buttons and M button at the same time for 5 seconds until the screen displays "C-I".
The display will last for 5 seconds. If there is no operation, the setting status will exit.
2) At this time, if users click the "1" button, the screen displays "C" and the switch to metric display is
completed ; if users click the "2" button, the screen displays "I"and the switch to imperial display is
completed.
8. Switch Jog and Continuous Mode of Memory Button
1) Press the up button, the "1" and the "2" buttons at the same time for 3 seconds until there are 2 beeps,
then switch to the jog mode of the memory button.
2) Press the up button, the "1" and the "2" buttons at the same time for 3 seconds until there is 1 beep, then
switch to the continuous mode of the memory button.
7