Miscellaneous - HP LaserJet 2605, 2605dn, 2605dtn Reference

●
ERROR: limitcheck
OFFENDING COMMAND: showpage
STACK:
(r)
(Sys/Start)
(Sys/Start)
If the PCL6 job is allowed to continue to finish then the PS job will complete normally. The size
does not seem to matter here. However, if a PCL6 job is canceled and a PS job is run afterwards,
no matter how big the document, this error occurs. If a print job is run immediately after this error
occurs it prints correctly.
Solution: None.
●
Solution: Perform an NVRAM initialization to return the printer to a Ready state. For more
information on appropriate IP address subnet mask combinations please refer to KRS document
number c00556327 titled "Determining Appropriate Static and Dynamic IP Ranges".
●
Cause: Supplies Status values for cartridges that have reached the out state are no longer valid
when "Override out" is in use.
Solution: Do not enable "Override out". Override out can only be enabled from the printer control
panel (System Setup>Print Quality>Replace Supplies>Override out).
●
Cause: This could only occur if two yellow or two magenta cartridges were installed in the printer
and one of them were installed in the cyan slot.
Solution: Verify that the correct cartridges are installed in the correct locations. From top to bottom
the cartridge order is black (K), yellow (Y), cyan (C), and magenta (M).

Miscellaneous

●
Issue: When printing on special media or paper, print quality issues may arise if the correct paper
type is not configured in the printer driver.
Solution: When printing on special media or paper (e.g. glossy paper), it is necessary to configure
the print driver for the type of media or paper that is loaded into the printer's tray(s) in order to
optimize print quality. Configuring the printer driver with the correct paper type signals the printer
to use more or less heat and adjust print speed for a particular paper type. Use the following steps
to print on special media:
NOTE
120 g/m² from Microsoft Word 2003.
1. Choose File, Print from the Menu bar in Microsoft Word.
2. Verify that the HP Color LaserJet 2605 series printer is the selected printer.
3. Click the Properties button (in some applications this may be the Preferences button).
4. Click the Paper/Quality tab and locate the "Type is" setting under the Paper Options section.
5. In the "Type is" box, click the drop-down arrow at the right and select "Glossy (106 - 120 g/
m²)" (or the appropriate type for the media or paper on which you are printing).
306 Chapter 8 Engineering Detail
The instructions below outline the steps for printing glossy paper with a weight of
ENWW