Flip Pages Up Option; Figure 5-14 Print On Both Sides Instructions - HP LaserJet 2605, 2605dn, 2605dtn Reference

NOTE
options, enable the Allow Manual Duplexing option on the Device Settings tab in the
Properties print-driver tabs. See the
If you want to print on both sides manually while using media that is supported by automatic
duplexing, you must select and apply the Not Installed setting on the Duplex Unit (for 2-Sided
Printing) option on the Device Settings tab.
Follow these steps to manually print on both sides.
1. Select the Print on Both Sides (Manually) check box.
2. Click OK. The even-number pages of the document print.
3. When the control panel shows the MANUALLY FEED message, insert the stack of media (on which
the even-number pages have been printed) as indicated in the following figure.
Figure 5-14
When you have completed the steps that appear in the dialog box, the second half of the print job
prints on the back side of the stack of media. The driver does not require the program to specifically
support odd- and even-page printing, because the driver coordinates this function.

Flip Pages Up option

Select the Flip Pages Up check box, which is enabled only when Print on Both Sides is selected, to
specify the duplex-binding option. By default, the Flip Pages Up check box is not selected. The following
table shows the results of selecting this box, depending on the paper orientation that you select on
the Finishing tab.
ENWW
To make the Print on Both Sides (Manually) check box available in the document
Print on Both Sides Instructions
Installable Options section of this chapter.
Finishing tab features 161