Endress+Hauser Proline Promass F 200 FOUNDATION Fieldbus Operating Instructions Manual page 123

Proline Promass F 200 FOUNDATION Fieldbus
Terminal assignment
Pin assignment, device plug
Supply voltage
Endress+Hauser
Block Number Contents
of
blocks
Discrete Input 1 This Block (standard functionality) receives a
Block discrete value (e.g. indicator that measuring
(DI) range has been exceeded) and makes the
value available for other blocks at the output.
Execution time: 19 ms
PID Block 1 This Block (standard functionality) acts as a
(PID) proportional-integral-differential controller
and can be used universally for control in the
field. It enables cascading and feedforward
control.
Execution time: 25 ms
Multiple Analog 1 This Block (standard functionality) receives
Output Block several analog values and makes them
(MAO) available for other blocks at the output.
Execution time: 22 ms
Multiple Digital 1 This Block (standard functionality) receives
Output Block several discrete values and makes them
(MDO) available for other blocks at the output.
Execution time: 19 ms
Integrator Block 1 This Block (standard functionality) integrates
(IT) a measured variable over time or totalizes the
pulses from a Pulse Input Block. The Block can
be used as a totalizer that totalizes until a
reset, or as a batch totalizer whereby the
integrated value is compared against a target
value generated before or during the control
routine and generates a binary signal when
the target value is reached.
Execution time: 21 ms
16.5 Power supply
(→  28)
(→  28)
Transmitter
An external power supply is required for each output. The following supply voltage values
apply for FOUNDATION Fieldbus and the pulse/frequency/switch output:
Technical data
Process variables (Channel)
• Status switch output (101)
• Low flow cutoff (103)
• Empty pipe detection (104)
• Status verification (105)
–
Channel_0 (121)
• Value 1: Pressure
• Value 2 to 8: Not assigned

The pressure must be
transmitted to the device
in the SI basic unit.
Channel_DO (122)
• Value 1: Reset totalizer 1
• Value 2: Reset totalizer 2
• Value 3: Reset totalizer 3
• Value 4: Flow override
• Value 5: Start heartbeat
verification
• Value 6: Status switch output
• Value 7: Start zero point
adjustment
• Value 8: Not assigned
–
123