Table of Contents
Advertisement
DI-206 ISDN Remote Router
Hardware Revision – This is the version ID of hardware used in this router.
Boot PROM Firmware Version – This is the version ID of firmware used in this
router.
MAC Address – This is the physical address for this router.
TCP/IP Parameters Configuration
The parameters are described as follows:
Interface – The LAN interface must use Ethernet/Fast Ethernet and is displayed
here. This setting cannot be adjusted.
IP Address – This is the router's IP Address for the LAN interface.
Subnet Mask – This mask shows how the LAN is to be divided into network,
subnet, and host parts.
Default Gateway – This is the default gateway for the LAN. If this router will be
the default gateway for the LAN, then the address should be 0.0.0.0.
Send BootP request upon power up – If set to Yes, when the router boots up, it
will attempt to acquire the path to the image file, the TFTP server IP Address and
the routers own IP Address.
System Reset
The system reset function enables you to reset the DI-206 without powering off.
Some setting changes require a system reset in order for them to take effect.
A system reset will not affect the router's settings, but will clear all tables including
the routing table and all SNMP counters and tables. It is also used to initiate a
software update.
86
Advertisement
Table of Contents
