Recording; Recording From The Radio Or Connected Equipment - Aiwa NSX-999 Operating Instructions Manual

Aiwa compact disc stereo system nsx-999 operating instructions
Hide thumbs Also See for NSX-999:
Table of Contents

Advertisement

1
DOLBY NR
b
3
1
1
REV MODE
(DECK /2)
b
RECORDING FROM THE RADIO OR
CONNECTED EQUIPMENT
Preparation
" Wind up the tape to the point where recording will start.
Use normal (type I) or Cr02 (type II) tapes.
1
2
3
4
5
Insert the tape to be recorded on into deck 2.
Press the EJECT A mark to open the cassette holder.
Insert the tape with the side to be recorded on first facing you
and the exposed side down.
Push the cassette holder to close it.
Set DOLBY NR.
To record with DOLBY NR: Press the DOLBY NR button to turn
on the Dolby NR. The 00 NR indicator will light.
To record without DOLBY NR: Press the DOLBY NR button to
turn off the Dolby NR, The 00 NR indicator will go off.
Set the reverse mode.
Each time the REV MODE button is pressed, the reverse mode
changes.
To record on one side only, turn on =.
To record on both sides, turn on =>.
Press the TUNEFUBAND or VIDEO/AUX
button to
select the source to be recorded from and play it.
Press the
REC/REC MUTE button to start record-
ing.
When you use the remote control to start recording, first press
the
/0 REC/REC MUTE button and then press the 4-
button within 2 seconds.
To stop recording
Press the
button.
To pause recording
Press the II button.
To resume recording, press it again.
TO INSERT 4-SECOND BLANK SPACES
Blank spaces in the recording allow you to activate the Music
Sensor function (see page 38). (Applicable when the source is
TUNER or VIDEO/AUX.)
1 Press the
REC/REC MUTE button during record-
ing or from recording pause mode.
REC flashes in the display for 4 seconds and the tape runs
without recording. After 4 seconds the deck enters recording
pause mode.
2 Press
the II button to resume recording..
To insert a blank space of less than 4 seconds
After pressing the
REC/REC MUTE button, press it again while
REC is blinking to resume recording.
To insert a blank space of more than 4 seconds
After the deck enters recording pause mode, press the
REC/
REC MUTE button again. Each time it is pressed, a4-second blank
space is added.
46

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Cx-n999Sx-n999

Table of Contents