Recording - Aiwa NSX-S222 Operating Instructions Manual

RECORDING
This section explains how to record from the tuner, CD player, or
external equipment.
Preparation
« Use Type I (normal) tapes only.
* Set the tape to the point where recording will start.
* Note that recording is done on only one side of the tape.
1 Insert the tape to be recorded on into deck 2.
Insert the tape with the side to be recorded on first facing out
from the unit.
2 Press function (CD, TUNER or VIDEO/AUX) and
prepare the source to be recorded.
To record from a CD, press CD and load the disc(s).
To record from a radio broadcast, press TUNER and tune
in to a station.
To record from a connected source, press VIDEO/AUX.
3 Press @ REC/REC MUTE to start recording.
When recording from a connected source, start playback of
the source.
REC
When the selected function is CD, playback and recording
Start simultaneously.
To stop recording, press Ml.
To pause recording, press II. (Applicable when the source is
TUNER or VIDEO/AUX) To resume recording, press it again.
Sound adjustment during recording
The output volume and tone of the speakers or headphones are
freely varied without affecting the recording.
If squealing or beating sounds occur when recording an MW or
LW broadcast, press MONO TUNER while pressing SHIFT on
the remote control, so as to eliminate the noise.
By pressing the buttons repeatedly, the dot light is turned on and
off in the display window:
INSERTING BLANK SPACES
Insertion of 4-second blank spaces enables you to activate the
Music Sensor function. (Applicable when the source is TUNER
or VIDEO/AUX.) :
1 Press @ REC/REC MUTE during recording or while in
recording pause mode.
on the display flashes for 4 seconds and 4-second blank
space is made. Then, the deck enters the recording pause
mode.
2 Press II to resume recording.
To insert a blank space of less than 4 seconds, press @
REC/REC MUTE again while is flashing.
To insert blank spaces of more than 4 seconds, after the deck ©
enters recording pause mode, press @ REC/REC MUTE again.
Each time the button is pressed, a 4-second blank space is added.
About cassette tapes
¢ To prevent accidental erasure, break off the plastic tabs
on the cassette tape after recording with a screwdriver or
other pointed tool.
Tab for side A'
To record on the tape again, cover the tab openings with
adhesive tape, etc.
¢ 20-minute or longer tapes are extremely thin and easily
deformed or damaged. They are not recommended.
* Take up any slack in the tape with a pencil or similar tool
before use. Slack tape may break or jam in the mechanism.
NOTE
"CAN'T REC' is displayed if you attempt to record on a tape with -
the plastic tabs broken off.
To erase a recording
1 Insert the tape to be erased into deck 2 and press TAPE DECK
1/2 to display "TP 2".
2 Set the tape to the point where the erasure is to be started.
3 Press @ REC/REC MUTE to start the erasure.