Dwhen Using The Dr Function - Icom ID-52A PLUS Manual

4
Access Point mode operation
■ Making a Gateway call through the Access point transceiver

DWhen using the DR function

NOTE: If you have imported the Repeater List, you have to register the Access Point information again
because the Repeater List is overwritten.
In this document, the ID-51A (PLUS2)/ID-51E (PLUS2) is used as a Remote D-STAR transceiver as an example.
1. Register the Access Point information to the Repeater List
L Register the Access Point information in the MENU
screen.
(MENU > DV Memory > Repeater List)
1. Select a group you want to add your Access Point
information.
2. After selecting a group, open the Repeater List
Edit screen.
(QUICK MENU > Add)
3. Set "DV Repeater" to "TYPE." *
L " DV Repeater" is used for Repeater operation in the
DV mode.
4. Enter your favorite name into "NAME" and "SUB
NAME." (Example: MY AP)
5. Set the Access Point transceiver's call sign to
"CALL SIGN."
(Example: JL3YRP)
L After setting "CALL SIGN," "GW CALL SIGN" is
automatically set.
6. Set "YES" to "USE (FROM)."
7. Set the Access Point transceiver's operating
frequency to "FREQUENCY."
(Example: 430.850)
8. Set "DUP" to "DUP–."
9. Set "0.000.00" to "OFFSET FREQ."
10. Select "<<Add Write>>" and write the Access
Point information.
* For only the ID-31A/E PLUS, ID-51A/E (PLUS),
or ID-51A/E (PLUS2)
26
*