Page 1
750w² Monitor Quickstart Guide Connect the sensor. Measure Plug the sensor into the port on the right-hand Press the On/Off button if the monitor isn’t side of the 750w2 Monitor. already displaying a reading. Use the menu. Charge as needed. Press the Menu button and use the arrow keys Connect a charging cable to the left port to access menu options.
Page 2
Sensor Calibration Suspended Solids Sensor - Zero Calibration Use the Set Zero function to perform a zero calibration. Start by immersing the sensor in clean water. Use a dark container to prevent interference from ambient light. Press Menu on the Select Measurement Select Suspended Choose Set Zero and...
Page 3
Press Dissolved Oxygen Sensor - 100% Open Air Calibration Calibrate the RDO sensor using the saturation method described below. See the manual for the Partech 750w2 Monitor to get more information about calibration. Highlight Calibrate Press Menu on the...
Page 4
For more information on the OxyTechw RDO 750 sensor or the 750w monitor, please refer to the 750w instruction manual that can be accessed and downloaded at: https://in-situ.com/us/750w-portable-monitor Technical support is available by phone or email. Outside the United States Phone: +44 (0) 1726 879800 Email: techsupport@partech.co.uk...
Need help?
Do you have a question about the partech 750w2 and is the answer not in the manual?
Questions and answers